Assuming you have a RGB laser with analog brightness control, you can trim the colour response to optimise it. (These instructions are taken from Pangolin tutorial https://youtu.be/BOX0U0b0qSE ) In Projector settings > Colour settings select “Analog with log response”. Show the “Grey scale test” test pattern: You’ll find that it may not be displayed properly, […]
Category: Laser Setup
FB4(1)
ILDA test pattern
The inner box needs to be shown at 8º. That means for every meter from the laser aperture, the box needs to be 14cm wide: 1m away = 14cm wide 1.5m away = 21cm wide 2m away = 28cm wide You need to adjust the scan rate (pps) so that the blue circle is just […]
Projection Zones
Defining projection zones Altering order of created zones in the list ALT + mouse drag Using zones for effects In a page of cues right click a cue (or use CTRL+A to select all on a page then right click), select Cue properties > Destination tab Saving setups Save a zone file directly from the […]
Projector Settings
Size and position Image size and position Typically you just set to 100×100, but can be useful when needing a specific size for the ILDA pattern or when setting up different lasers to match. Scan rate Default sample rate Set to match your projector’s capability. The industry default is 30000 pps, but use the ILDA […]
TCP / Turbo streaming
Selected using the bottom toolbar button in Beyond: TCP gives you all the protections of handshaking on the Ethernet link between Beyond and each FB4. In the event of packet loss the packets will be retried. This could result in stuttering or laggy moments on congested networks. Turbo uses UDP, which is fire each packet […]